Star Micronics SM-S220i-DB40 Handbuch

Mobile PrinterSM-S220I SERIES Hardware Manual

- 3 -1.2 External Appearance and Part NamesCOM1(Serial 6P)For connecting to the host deviceFor connecting to a PIN pad or RFID moduleCOM2(NFC/PED 8P)

- 4 -2. Setup2.1 Battery Pack2.1.1 Inserting into the Printer1. Make sure that the printer has been turned o before you insert or remove the batter

- 5 - Notes about the Battery PackuGeneral Battery Characteristics• The battery is a consumable and its performance over time will gradually decr

- 6 -< For U.S.A. and Canada >Lithium-Ionbatteriesarerecyclable.Youcanhelppreserveourenvironmentbyre-turning your used rechargeable b

- 7 -2.2 Bluetooth2.2.1 Connection1. When you turn on the printer, it is ready to pair with another Bluetooth device.2. If necessary, enter the foll

- 8 -2.2.2 Auto Connection Function (only for iOS*1)When the Bluetooth connection with your iOS device(*2 is disconnected, it is required to establish

- 9 -2.3 Loading PaperRefer to chapter 4, “Paper” (page 20), to select roll paper that conforms to the specications.1. Turn on the printer.2. Put

- 10 -4. Press down on both sides of the printer cover to close it rmly. When you close the printer cover, make sure that it is closed on both side

- 11 -2.4 Memory Switch Settings Change the Memory switch by this operation. (Refer to “Memory Switch Setting Table”). MODE button : Changing

- 12 -After you have congured all of the settings, press and release FEED and MODE at the same time. The new settings will be printed.If the settings

<USA model>Federal Communications Commission Radio Frequency Interference StatementFCC ID : R49SM-S220This device complies with Part 15 of the

- 13 -Printer Mode Setting Display1 Communication Port v1)Bluetooth(iOS) * Bluetooth(iAP)BluetoothBluetooth ModeRS-232CUART Mode2 Baud Rate9600 bps

- 14 -v1)Communication modeIt is possible to change the communication mode setting between Bluetooth and serial. Please see below for details to sele

- 15 -2.5 Belt Clip2.5.1 Attaching to the PrinterFollow the procedure below to attach the belt clip to the printer.1. Make sure that you are attachi

- 16 -3. Printer Features3.1 Control Panel3.1.1 Buttons1) FEED button: When the printer is on, you can press FEED to feed the paper.2) MODE but

- 17 -Printer Status ActionLEDLCD BuzzerPOWER(Green)ERROR(Red)Printer Initialization(Power On) Flickering FlickeringDisplay : [ Bluetooth Mode ]Back L

- 18 -3.2 Self TestYoucanuseaselftesttochecktheprinter’ssettings.Before you start the self test, make sure that roll paper has been properl

- 19 -3.3 Instruction for Auto Power Down(Sleep) ModeThe printer in the Power Down(Sleep) Mode will recover to the Print Ready Mode when receiving co

- 20 -4.2 Recommended Paper (Common thermal roll paper)Manufacturer Product NameMitsubishi Paper Mills Limited P220AGOji Paper Co., Ltd. PD450APPLETO

- 21 -5. General SpecicationsItem SpecicationsPrinting method Direct line thermal printingCharacters per line Maximum 42 cplCharacter sizeAlphanume

- 22 -n External SpecicationsExternal dimensions: Approximately 82 mm (W) × 140 mm (D) × 47 mm (H)Weight:   289g(printer+batterypack).

Trademark acknowledgmentsSM-S220I: Star Micronics Co., Ltd.Notice• All rights reserved. Reproduction of any part of this manual in any form whatsoeve

- 23 -Application of Council Directive(s)R&TTE 1999/5/EC of 9 Mar. 1999Standard(s) to which Conformity is Declared Radio ：EN 300 328 V1.7.1EN 5037

URL: http://www.starmicronics.com/support/Rev. 1.1

Caution SymbolThis symbol is placed near the thermal head to indicate that it may be hot.Never touch the thermal head immediately after the printer ha

n Using the Printer P Some semiconductors can be damaged by static electricity. Be sure to turn o the printer when inserting or removing the battery

n Operating Environment for the PrinterBefore actually unpacking the printer, you should take a few minutes to think about where you plan to use it. R

Table of Contents1. Product Overview ...11.1 Printer & Accessories ...

- 1 -iPod, iPhone and iPad compatibility listMade for • iPod touch (5th generation)• iPod touch (4th generation) • iPhone 5 • iPhone 4S • i

- 2 -1.1 Printer & AccessoriesThe printer is packaged with the following accessories.If any of these accessories is broken or missing, please con