Star Micronics TSP200-24 Bedienungsanleitung PDF herunterladen (Seite 134)

– 130 –

APPENDIX

A drive circuit for driving peripheral units (such as cash drawers) is featured on

the main logic board of this printer. A modular connector for driving peripheral

units is featured on the output side on the drive circuit. When using this circuit,

connect the cable for the peripheral unit. (Cables must be prepared by the user.)

Use cables which meet the following specifications.

1. Use the modular plug as shown in Figure below.

2. Separate ground wire is required for Europe only.

3. If the printer is used in Europe, the Ferrite core should be attached to the cable,

as shown in Figure below.

CAUTION: DO NOT connect any other plug to the peripheral unit connector.

Cable specifications for peripheral unit.

Separate ground wire and noise filter are required for Europe.

Ferrite core

1 turn

Ground wire

Modular plug MOLEX 90075-0007,

AMP641337 or JAPAN BURNDY B-66-4

Shield

Wire lead

Separated ground wire

connected to shield (Europe only).

Appendix D: Peripheral Unit Drive Circuit

1 2 ... 129 130 131 132 133 134 135 136 137 138

Keine Kommentare

Star Micronics TSP200-24 Bedienungsanleitung Seite 134